PROTETTIVO 15 - PROTECTIVE 15. Impregnating that protects and impermebifies the wood
Size 0,75 - 2,5 - 5 - 20 liters. Impregnating wood restoration
PROTETTIVO 15 - PROTECTIVE 15
It penetrates deeply into the wood fibers, protecting and waterproofing it, while allowing excellent breathability. Enhances the grain of the wood. This product does not require subsequent protection treatments with finishes other than on floors or for any aesthetic polishing needs.
This impregnating agent, thanks to the particular cooking of aleurites oil, used in its formulation, is particularly suitable for the treatment of wood, outdoors. Colors: Neutral, colourable with earth and natural oxides.
It penetrates deeply into the wood fibers, protecting and waterproofing it, while allowing excellent breathability. Enhance them
wood grains. This product does not require subsequent protection treatments with finishes other than on floors or for any aesthetic polishing needs.
METHOD OF USE
Surface preparation: Remove any old varnishes and grease or glue stains. There
surface to be treated must be dry, absorbent and clean.
For optimal product absorption, the wood moisture must be less than 15 - 20%.
Cartatura: it is possible to sand up to 180-220 fine grains.
Application of the product: Mix the product well, and apply the brush or spray on the prepared surface. Colored products do not need to be carefully mixed before application.
The product must be well absorbed by the wood, and spread avoiding the formation of accumulation areas. The brush must slide easily. After about 30 min. from the application it is possible to pass with a cotton cloth, to eliminate excess of product from the surface. This operation may be necessary, if you apply the product on small surfaces, where it is difficult to spread the brush well.
Dilution: 5-10% of citrus balm can be diluted, 43.
For ambient temperatures below 7-8 ° C, it is recommended to increase the dilution, to promote absorption.
Drying: Dust free in c.ca 2 h. Dry in 24 hours, under normal conditions.
Second hand: Spread the next coat, after lightly sanded, with fine paper No. 180 or with an iron wool.
The hands to be applied are dependent on the absorption of the wood. In general, two coats of product are sufficient.
From 18 to 20 sqm / l
Customers who bought this product also bought:
PURE BRISTLE BRUSH - width 4-7cm
TANNIN STOP - Block and stain the wood tannin
Cork panels 1 to 10 cm thick -...
BIOART ADHESIVE / SKIMMING FOR CORK...
Bioart- THERMAL COATING FINE STICKER...
Compressed roll cork - 2-3-6-10 mm -...
Last blog articles
No newsSee all